There are many conventional cleaning and polishing products that can be used on ENVIRAWOOD, but to achieve the ultimate shine and to reduce smudges we suggest using Nano Power Finish which is distributed by CTA Products.
Visit: www.powerthreads.com to locate the nearest distributor.
We also recommend 3M #09033 Marine Clean and Shine Spray Wax. Simply spray on the surface and wipe off using
a 3M #26224 Scotch-Brite High Performance Cloth.
No different than expensive solid wood and wood veneer finishes, the ENVIRAWOOD finishes can sooner or later get damaged. However, wood finishes are far more vulnerable to damage under normal wear and tear conditions than the ENVIRAWOOD finishes therefore ours require considerably less maintenance.
Repairing damaged sections or entire components in solid wood and wood veneers can be extremely difficult and very expensive depending on the type and extent of the damage. Replacement is even more of a challenge since no two trees are exactly the same. An exact or acceptable match is virtually impossible to achieve due to the variations in grain, color and the unavoidable aging of solid wood and wood veneer caused by exposure to indirect light or even worse, direct sunlight.
Since ENVIRAWOOD finishes can also be damaged we strongly recommend replacing the damaged area using a new and readily available prefinished ENVIRAWOOD veneer sheet, panel or component. This is definitely the most cost-effective, permanent and visually appealing repair solution. Unlike natural wood and wood veneer replacements the grain and color match of the new ENVIRAWOOD veneer sheet or component will be an exact match to the original. Obviously, a major advantage this innovative, man-made veneer product offers and why we strongly recommend replacement over the repair
of a visibly damaged area.
In the event the removal of a damaged area is impractical or impossible, contact technical support at ENVIRAWOOD